This kind of stainless steel handrail, with steel wire ropes threaded in the middle, columns spaced one meter apart, and fixed with expansion screws, can not only protect the safety of tourists but also decorate the environment. It can be used for 30 years without problems.
If you like it, leave a message and I will send you the quotation sheet.

A keyed glass-to-wall latch that closes the last gap in a frameless pool fence. The magnet pulls the gate home from any position; the lock keeps it that way. Cast in SS316 marine grade for salt air and wet decks, sized for 3/8"–1/2" (8–12mm) tempered glass, in matte black or brushed finish.

A square base-plate spigot cast in Duplex 2205, built for one job: holding 10–13.52mm
glass panels plumb on a slab that is never perfectly level. The base plate has slotted
holes, so you set the anchors, drop the spigot, then fine-tune with the levelling plate
and four M10 screws instead of shimming or re-drilling. Supplied as one kit — body,
cover, gasket, levelling plate, screws. Satin, mirror or matte black.

A frameless glass railing built around a cast base-plate spigot, not a post-and-rail
frame — so nothing interrupts the view. 12mm (0.47") tempered glass panels sit in
Duplex 2205 or SS316 spigots: choose Duplex 2205 for pools and coastal decks, where
chlorides stain standard stainless in a few seasons. Panels are cut to your sizes;
the common panel is 39.4" × 59.1" (1000 × 1500mm). Three finishes. MOQ 10 pcs.

A slim 25.4 mm (1") stainless slotted tube that caps frameless glass and turns the panel edge into a handrail. The 14 x 14 mm groove grips 10 mm or 12 mm glass directly - no top channel, no exposed fixings. SS316L as standard for pool and coastal work, in mirror, satin or black, supplied in 2,800 mm and 5,800 mm lengths with matched end caps, joiners and wall connectors.

Aluminum picket railing extruded from 6063-T5 and powder coated to a UV-stable finish —
it will not rust, peel or need repainting. Standard 36" (914 mm) and 42" (1,067 mm)
heights, with picket spacing held under 4" (100 mm). Black ships from stock; any Pantone
or RAL colour on order. Send your layout — we return a shop drawing and a quote in 24 hours.

An aluminum base shoe grips the panel along its full bottom edge, spreading load continuously instead of concentrating it at a few clamp points — so frameless runs are often specifiable with thinner glass than spigot or standoff layouts. Extruded in 6063-T5, stocked in 4 m (13.1 ft) lengths for fewer joints, it accepts 10 mm tempered through 19 mm laminated, including the 13.52 mm (9/16 in) and 17.52 mm (11/16 in) build-ups used for uncapped glass guards. Supplied with gasket and wedge set, cut to your panel schedule. Natural anodized or black. Sold by the meter, 1 m MOQ.